COLLAR: Using dimensions of the collar template cut out your collar paying close attention that the collar fronts will match when finished. Hem ¼-inch on each end of the collar fronts. Using the template, mark tucks and direction of the folds. Make the folds, pin in place, stitch just inside the seam line by machine. 11. Pin collar to dress neck edge as indicated. The left side is set ¼-inch from center front line. The right side of collar is set at center front of dress. Clip the dress neck edge and fit collar to dress neck, pinning as you go. I machine-stitched this edge. 12. Set facing over collar, clip curve, pin in place and stitch. Trim seam, turn and baste close to dress neckline to hold in place. 10. SET SLEEVES: 13. Match the notch in the under sleeve to the dress side seam. Match the notch in the upper sleeve to shoulder seam pinning both. Clip the armscye of the dress and spread to fit the sleeve, pinning as you fit. Hand-stitch the armscye seam with tiny stitches and double thread. Trim seam slightly and overcast. 28 WiNtEr 2018